Home > News > Content

Precautions for Operation of LCD 3D Printer(1)

Apr 27, 2020

Matters needing attention before printing


1. After the equipment is purchased, remove the outer packaging. Please note that the power supply and its accessories are in the built-in foam of the hood. Please open to confirm.

 

power supply and its accessories are in the built-in foam of the hood


2. After unpacking, first power on to confirm the operation status of the device.

① Turn on the power switch at the rear right of the device;

② After loading the boot animation, click the manual button in the tool, lift the shaft to a certain height, and remove the dust-free paper in the resin pool;

③ Remove the resin pool and the printing platform (note the arrow mark on the printing platform, and install it on the printer in the same direction when installing again);

④ Click on the full-screen exposure. After ensuring that the screen is not abnormal during transportation and the surface is clean, install the printing platform and the resin pool to the original position. After placing it in place, tighten the nut.

The above steps are mainly for removing the dust-free paper in the resin pool and teach customers the details before use. 



These details if you don’t pay attention,there will be an abnormality in the screen itself during transportation. The customer directly prints after getting the device, that is, nothing is printed and wastes materials, and the screen cannot be diagnosed as a transportation problem or an abnormality during the printing process.

Or the printing platform is not placed on the innermost side and printing starts.